 |
 |
 |
|
- Steel frame provides strength and quiet operation
- "T-Handle"release is easily accessible from front of operator
- Operator re-connects automatically when handle is released
- Direct driven limit nuts for precise gate control
- Auto-close timer 1-30 seconds
- Ports for plug-in open and reverse loop detectors - DKS detectors only
- Selectable loop/reverse input function; stop or reverse
- Anti-tailgating feature helps to control un-authorized traffic
- Standard normally closed stop circuit
- Gate Tracker reporting output provides operator data to DKS access control system
- Convenience outlets for accessory transformers
- Built-in power switch and alarm reset switch
- Simple bi-parting gate interface
- Maximum gate width 35-ft.
- Maximum gate weight 1000 pounds* (1/2 HP) or 1500 pounds* (1 HP). (*Assumes gate is on level ground, in good condition with properly adjusted hardware. Other external factors may affect the performance of the gate operator.)
- 1/2 or 1 HP continuous-duty motor115, 230*, 208*, 460* VAC. (*230, 208, and 460 volt units use a step-down power transformer to achieve 115 volt operating voltage.)
- Class I, II, III and IV applicationsCompliant with UL 325 and 991, ETL Listed. (Note: To be compliant with UL 325 and industry safety guidelines, additional Type B1 and/or Type B2 entrapment protection devices are required to be installed with this gate operator.
- Dimensions: 18.375"W x 31.675"H x 23.25"D
Options: - Plug-in loop detectors.
- Heater kit for cold environments.
- Secondary entrapment prevention devices.
- Bi-parting gate connection cable.
- Gate operator control stations
- Postal and Fire Dept lock boxes
- Surge suppressors, time clocks, traffic signal.
|
|
|
 |
|
 |
|
|
|
 |
|
 |
|
Features
- Maximum gate width 35-ft.
- Maximum gate weight 1000 pounds* (1/2 HP) or 1500 pounds* (1 HP). (*Assumes gate is on level ground, in good condition with properly adjusted hardware. Other external factors may affect the performance of the gate operator.)
- 1/2 or 1 HP continuous-duty motor
115, 230*, 208*, 460* VAC. (*230, 208, and 460 volt units use a step-down power transformer to achieve 115 volt operating voltage.)
- Class I, II, III and IV applications
Compliant with UL 325 and 991, ETL Listed. (Note: To be compliant with UL 325 and industry safety guidelines, additional Type B1 and/or Type B2 entrapment protection devices are required to be installed with this gate operator.
- Dimensions: 18.375"W x 31.675"H x 23.25"D
Options:
- Plug-in loop detectors.
- Heater kit for cold environments.
- Secondary entrapment prevention devices.
- Bi-parting gate connection cable.
- Gate operator control stations
- Postal and Fire Dept lock boxes
- Surge suppressors, time clocks, traffic signal.
|
|
|
|
|
|
|
